New Beetle L4-2.0L (BEV) (2004)
/Page-1241001.png)
Brake Pedal Assy: Service and Repair
Brake Pedal, Assembly Overview
Brake pedal, assembly overview
WARNING: The brake pedal travel must not be restricted by additional floor coverings.
Note: Grease all mountings before installing with grease Part No. G 000 602.
1. Mounting bracket
2. Self-locking hex nut, 20 Nm (15 ft. lbs.)
3. Brake light switch for vehicles up to m.y.O2.00
^
Before installing new brake light switch, connect brake pedal to brake booster push rod
^
Before installing pull plunger out completely
Installing:
CAUTION: Keep brake pedal in the down position and hold pedal while installing switch.
^
Guide switch through mounting hole (only fits in one position) and secure by turning 90 clockwise
^
Release brake pedal
^
Connect brake light switch connector
^
Check function of brake lights
4. Brake light switch for vehicles from m.y. 03.00
^
Before installing new brake light switch, connect brake pedal to brake booster push rod
^
Before installing pull plunger out completely
Installing:
CAUTION: Keep brake pedal in the up position and hold pedal while installing switch.
^
Guide switch through mounting hole (only fits in one position) and secure by turning 45° clockwise
^
Release brake pedal
^
Connect brake light switch connector