New Beetle L4-2.0L (BEV) (2004)
^
Remove vibration damper/belt pulley.
^
Remove engine bracket from cylinder block.
Note: When loosening the front engine mounting bolt the engine must be raised slightly with the support bracket.
^
Remove toothed belt guard center and lower parts.
^
Mark direction of rotation of toothed belt.
^
Release tensioner and take off toothed belt.
^
Turn crankshaft back slightly.
Installing
Requirements
^
Pistons must not be positioned at TDC.
Work sequence
^
Place toothed belt on crankshaft pulley and coolant pump (observe direction of rotation).
Note: Engine removed:
Begin by installing lower section of toothed belt guard as well as belt pulley/vibration damper.
Adjusting valve timing
Note: When the camshaft is turned, the crankshaft must not be at TDC. Danger of damage to valves or piston crowns.
^
Bring mark on camshaft into line with mark on toothed belt guard.