New Beetle L4-2.0L (BEV) (2004)
Timing Belt: Testing and Inspection
Semi-automatic toothed belt tensioning roller, checking
Special tools, testers, measuring instruments and auxiliary items required
^
T10020 Two hole pin wrench
Installed position
^
Angled retainer (arrow) must locate in cutout on cylinder head.
Requirements
^
Engine must only be hand touch warm.
Work sequence
^
Set engine to TDC No. 1 cylinder.
^
Press hard with thumb on toothed belt. Indicator -2- must move.
^
Release thumb pressure on toothed belt and turn crankshaft two turns in engine direction of rotation until engine is again at TDC No. 1 cylinder.
Last 45° (1/8 turn) must be performed without stopping.
Tensioning roller must return to its original position (notch -1- and indicator -2- are again aligned).
Note: Use a mirror when checking.