New Beetle L4-2.0L (BEV) (2004)
-
Check wires between test box and 6-pin connector for open circuit according to wiring diagram. Terminal 1 + socket 72, Terminal 2 + socket 73,
Terminal 3 + socket 36, Terminal 4 + socket 35, Terminal 5 + socket 33, Terminal 6 + socket 34: Wire resistance: max. 1.5 Ohms
-
Also check wires for short circuit to each other, to vehicle Ground (GND) and to B+: Specified value: Infinite Ohms
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace Throttle Position (TP) sensor, item 4.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes