New Beetle L4-2.0L (BEV) (2004)
-
Pull multi-function switch -4- along with washers -2- and -3- off selector shaft -6-.
Installing
Install in reverse order. When doing this note the following:
-
Install multi-function switch -4- onto selector shaft -6-.
-
Tighten multi-function switch securing bolts -5- hand tight.
-
Bend back hooks of locking plate -2-.
-
Place washers -2- and -3- onto selector shaft -6-.
Note:
^
Install washer-2- with hooks facing upward.
^
Install washer-2- with long thin guides into long thin recesses of selector shaft -6-.
-
Tighten nut -1- to 7 Nm.
-
Secure nut -1- by bending up hooks on locking plate -2-.
Note: If one or more hooks of the locking plate break off while bending, the locking plate must be replaced.
-
Install lever -3- onto selector shaft -4-.
-
Place transmission in position "P" using lever -3-. To do this, push lever -3- toward rear of vehicle onto limit stop.
-
Select position "N" on transmission using lever -3-. To do this, move lever -3- two detents toward front of vehicle.
-
Fit spring ring -2- and nut -1- onto selector shaft -4-.
-
Tighten nut -1 to 13 Nm.