New Beetle L4-2.0L (BEV) (2004)
NOTE: Resistance value is valid at approx.. 20 degrees C. At higher temperatures, resistance value increases.
If specified value is not obtained:
-
Replace faulty fuel injector:
-
Vehicles with engine code AEG, AVH, AZG, item 7.
-
Vehicles with engine code BDC, item 9.
Note the following when installing the fuel injectors:
-
Replace O-rings on all fuel injectors and wet them slightly with clean motor oil.
-
Insert fuel injectors into fuel distributor perpendicular and in the right position, and secure them with retaining clips.
-
Position fuel distributor with secured fuel injectors on lower part of intake manifold and apply uniform pressure to press it in.
-
The connectors must audibly engage on valves when attached.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Checking voltage supply
Vehicles with engine code AEG
-
Connect diode test lamp to connector of fuel injector to be tested terminal 1 and Ground (GND).
Vehicles with engine code AVH, AZG, BDC
-
Connect diode test lamp to connector of fuel injector to be tested terminal 1 and Ground (GND).
Continuation for all vehicles
-
Operate starter and test voltage supply for fuel injector. LED must light up.
-
Switch ignition off.
If LED does not light up:
-
Check wire between 2-pin connector terminal 1 and the Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram. Wire
resistance: max. 1.5 Ohms