New Beetle L4-2.0L (BEV) (2004)
Headlamp Alignment Sensor: Testing and Inspection
Left Rear Level Control System Sensor -G76-, checking
NOTE: The rear level control system sensor is not externally adjustable. However it must be checked after installation is complete.
Special tool, testers, and auxiliary items needed
-
VAG 1551/1552 Scan Tool (ST) or VAS 5051 Vehicle Diagnostic Testing and Information System tester.
-
VAG 1551/3B Adapter Cable
Prerequisites
-
Vehicle must be standing on all four wheels on a flat level surface.
-
Handbrake lever must be in off position and a drive gear must not be selected.
-
Steering must be in straight-ahead position.
-
Vehicle must be unoccupied and not loaded.
-
Vehicle must not be moved during basic settings process (i.e.: opening and closing of doors, people leaning on vehicle, people entering vehicle is
not permitted).
-
If vehicle was raised using a lifting platform/hoist or a vehicle/workshop jack, then it must be rolled back and forth several times so that the
springs etc. settle, before starting adjustments.
VAS 5051 Vehicle Diagnostic Testing and Information System or VAS 5052 Vehicle Diagnostic and Service System, selecting functions:
See: Lighting and Horns/Headlamp/Headlamp Alignment Control Module/Service and Repair/On Board Diagnostic Function
VAG 1551/1552 Scan Tool (ST), connecting and selecting functions (function 01)
Prerequisites:
-
All fuses OK., according to wiring diagram
-
Voltage supply OK. (minimum 9.0 V).