New Beetle L4-2.0L (BEV) (2004)
-
Use hose clamp 3094 hose on power steering pump.
-
Remove noise insulation panel.
-
Place drip tray underneath.
-
Press tie rod end off steering arm.
A - Ball joint separator (commercial type) e.g. Kukko No. 128/2
-
Disconnect hoses from steering gear and seal with plastic bag and adhesive tape.
-
Seal threaded holes on power steering gear with plastic sealing plugs -1- and -2-.
-
Remove hex bolts -1- and -2-.
Vehicles with TDI engine
-
Separate exhaust system from subframe.
Continued for all vehicles
-
Support subframe with engine/transmission jack VAG 1383 A.
-
Remove hex bolts -1-.