New Beetle L4-2.0L (BEV) (2004)
-
Carefully slide cover forward over selector lever cable.
Note: Do not damage protective covering when doing this.
-
Unclip Shift lock solenoid -N110- from retainer (arrows -A-).
-
Pull Shift lock solenoid -N110- out of pawl (arrow -B-).
-
Take Shift lock solenoid -N110- out downward.
Installing
Install in reverse order. When doing this note the following:
-
Hook Shift lock solenoid -N110- into pawl (arrow -B-).
-
Clip Shift lock solenoid -N110- into retainer (arrows -A-).
-
Bolt cover with bonded seal onto selector lever housing.
Note: Ensure seal is positioned correctly.
-
Tighten nuts (arrows -A-).
-
Tighten 2 bolts (arrows -B-).
-
Reconnect exhaust system and install tunnel bridge.
-
Install selector mechanism and printed circuit board cover.
-
Install center console.
-
Connect battery Ground strap.
-
Check selector mechanism.
-
Enter radio code.
-
Initialize power windows, set correct time on clock.