New Beetle L4-2.0L (BEV) (2004)
/Page-1061003.png)
-
Remove oil pan along with gasket.
Installing
Install in reverse order. When doing this note the following:
-
Clean two magnets located in webs of oil pan. Make sure magnets have full contact with oil pan.
-
Install a new gasket to oil pan.
-
Make sure oil pan gasket is seated correctly.
-
Make sure no lines are caught/trapped when installing oil pan.
-
Tighten oil pan bolts (arrows) in several stages and in alternate and cross-over sequence.
-
Replace drain plug seal.
-
Install drain plug -B.
-
Install overflow pipe.
-
Fill with ATF, check ATF level and top off.
