New Beetle L4-2.0L (BEV) (2004)
Shift Interlock Solenoid: Service and Repair
6 Speed Automatic 09G
Shift lock solenoid -N110-, removing and installing
Removing
-
Check whether a coded radio is installed. If so, obtain anti-theft coding.
-
Move selector lever to position "R".
-
With ignition switched off disconnect battery Ground strap.
-
Remove selector mechanism and printed circuit board cover.
-
Disconnect connector (arrow) off Shift lock solenoid -N110-.
-
Pull rod upward and move selector lever to position "P" holding rod in upward position.
-
Raise vehicle.
-
Loosen double clamp -A- and slide to rear.
-
Remove tunnel bridge -B- located beneath exhaust system.
-
Remove heat shields -C- and -D-.
-
Remove 4 nuts (arrows -A-).
-
Remove 2 bolts (arrows -B-).