New Beetle L4-2.0L (BEV) (2004)
/Page-1099003.png)
^
Remove locking segment -2 bolts).
^
Move selector lever to "1".
^
Remove retaining bracket -7- (2 nuts).
^
Remove solenoid bolts -8- (Qty. 2).
^
Remove front selector mechanism nuts (Qty. 2).
^
Lift vehicle.
^
Disconnect exhaust system at double clamp -A-. Remove front bracket for exhaust pipe if necessary.
^
Remove cross support -B- below exhaust system.
^
Remove heat shield -C-.
^
Remove heat shield -D-.
^
Remove rear bolts for selector housing.
^
Support selector mechanism .
CAUTION!
Do not bend or kink selector lever cable.
^
With selector lever in "1" remove solenoid with locking pin and spring from selector lever housing (move selector lever slightly back and forth if
necessary).
Installing
Install components in reverse order of removal.
^
Adjusting locking cable.
^
Ignition key removal lock, checking.
^
Selector mechanism, checking.
