New Beetle L4-2.0L (BEV) (2004)
10. Cover
11. Selector lever housing
12. Bolt
13. Locking washer
^
For mounting pin item -15- of pawl item -14 -
14. Pawl
^
For selector lever lock
^
Grips into cable lever of selector lever housing
15. Mounting pin
^
For pawl item -14 -
16. Shift lock solenoid -N110-
17. Locking cable
18. Bolt
19. Steering lock
20. Clip
^
Installation position: Install clip from above. Angled ends of clip face steering lock.
Selector Lever Handle, Removing and Installing
Selector lever handle, removing and installing
Removing
-
Move selector lever to position "R".
-
Slide sleeve -1- downward.
-
Pull button -2- out of handle -4- onto limit stop (arrow).
-
Secure button against springing back with, for example, a wire pin -3-.
-
Pull handle off selector lever.
Installing
-
Move selector lever to position "R".
-
Pull button -2- out of handle -4- onto limit stop (arrow).
-
Secure button against springing back with, for example, a wire pin -3-.
-
Installation position: Button toward driver.
-
Push handle onto selector lever onto limit stop.
-
Remove wire pin.
-
Press button to lock pull lever -5- into pull rod -6-.
-
Button must now spring back onto limit stop.
-
Slide sleeve -1-, in a twisting motion, upward until lug in sleeve perceptibly engages into slot in handle -4-.
-
Move selector lever to position "P".