New Beetle L4-2.0L (BEV) (2004)
-
Remove bolt -6-.
-
Carefully remove Transmission fluid temperature sensor -G93- -7- along with retainer from valve body.
Note: For the reinstallation, note the mounting of the retainer for the Transmission fluid temperature sensor -G93-.
-
Unclip wiring harness on retainer -8-.
-
Disconnect connector -1- from transmission.
-
Remove bolt/screw securing 8-pin transmission connector.
-
Pull connector and wiring outward out of transmission housing.
Installing
Install in reverse order. When doing this note the following:
-
Replace O-ring on connector.
-
Push connector with new O-ring into transmission onto limit stop.
-
Tighten bolt/screw for 8-pin transmission connector.
-
Tighten securing bolt/screw for Transmission fluid temperature sensor -G93- retainer to 11 Nm.
-
Install oil strainer.
-
Install oil pan.