New Beetle L4-2.0L (BEV) (2004)
-
Open door and place 3 pieces of tape along the top of the window as indicated in the illustration -arrows-
-
Close door and mark the depth of window entry into the window slot
-
Open door and using a scale measure the window entry depth
-
Depth needed is 8 mm±1 (.28 in. - .35 in.)
-
Remove rubber plugs on the bottom of the door, use a T30 Torx driver and turn screw clockwise to raise window or counter- clockwise to lower
window to get to the required depth
NOTE: By turning the Torx screw one revolution, the window will move 1 mm (0.04 in.)
-
Partially open convertible top
-
Raise door window and rear window to the top position
-
The height -a- of both windows should be the same, otherwise perform the Z - axis adjustment
-
The distance -b- (measured horizontally near the top of the windows) must be equal to 9.5 mm±0.5 (0.35 in. - 0.39 in.) otherwise repeat the Z -
axis adjustment
NOTE: Illustration is showing the left door window and rear glass
-
Reinstall rubber plugs at the bottom of the door
-
Close convertible top
-
Repeat procedure on opposite front door.
-
Tighten the ground (GND) cable to battery to 5 Nm. (44 in. lbs.)
-
Perform power restoration procedure.