New Beetle L5-2.5L (BPR) (2007)
Global Positioning System Module: Testing and Inspection
Telematics Control Module (J499), Coding
Telematics
Telematics Control Module (J499), Coding
Special tools, testers and auxiliary items required
‹› Vehicle Diagnostic, Testing and Information System ( VAS 5051B)
If the Telematics control module was replaced, it must be coded and configured for the OnStar system.
‹› Do not swap out any Telematics control modules between different vehicles! Each Telematics control module has a special identification and an
electronic serial number that matches the VIN. Using this data, the vehicle is identified by the OnStar Call Center and assigned to the respective
customer account.
‹› To diagnose, use the "Guided Fault Finding" function of the (VAS 5051B). Before removing the Telematics control module, while diagnosing
with the (VAS 5051B) in the " replacing the J499 - Telematics control module" function, the option will be offered to read out the coding and then
reprogram it in the new Telematics control module after it has been replaced.
Procedure:
-
Connect (VAS 5051B).
-
In (VAS 5051B), select operating mode " Guided Fault Finding".
-
Using the Sprung button, select "Functions/Component selection" and the following menu options in the following sequence:
‹› Body
‹› Electrical Equipment
‹› 01 - On Board Diagnostic (OBD) capable systems
‹› Telematics NAR
‹› Telematics NAR functions
‹› Control module, coding