New Beetle L5-2.5L (BPR) (2007)
-
Insert brake pedal actuator (V.A.G 1869/2 ).
-
Attach bleeder bottle bleeder hose to left front and right rear brake caliper bleeder screw and open bleeder screws.
-
Operate brake pedal using brake pedal actuator at least 60 mm.
-
Close left front and right rear bleeder screws.
-
Do not remove brake pedal actuator (V.A.G 1869/2 ).
-
Place a sufficient number of lint-free cloths under control module and hydraulic unit.
CAUTION!
Make sure that the brake fluid does not come in contact with the terminals.
-
Remove brake lines from ABS hydraulic unit (N55 ) - 1 - to master brake cylinder and tie up.
-
Remove remaining brake lines from ABS hydraulic unit (N55).
-
Seal brake lines and threaded bores using plugs from repair set (1H0 698 311 A).
-
Remove bolts - arrows - from bracket for control module/hydraulic unit.
-
Remove ABS hydraulic unit (N55) together with ABS control module (J104).
Control Module, Removing from Hydraulic Unit
-
Place hydraulic unit with control module on a clean and flat surface on the floor.