New Beetle L5-2.5L (BPR) (2007)
Installing, adjusting and locking new brake light switch (from 11.06, with the exception of 2 pin brake light switches) => [ Installing, adjusting and
locking ] See: Brake Light Switch, From 12.06.
Exception: 2 pin Brake Light Switch
To ensure secure installation, install brake light switch only once.
Before assembling the brake light switch, grease plunger head with polycarbamide grease (G 052 142 A2).
-
Before installing, pull plunger out fully.
-
Push brake pedal down as far as possible by hand.
-
Guide brake light switch through fitting hole and reinstall by turning 90 degrees to right.
-
Release brake pedal.
-
Fit brake light switch connector.
-
Check function of brake light.
-
After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).