New Beetle L5-2.5L (BPR) (2007)
-
Slide subframe far enough until camber is equal on both sides.
-
Check caster angle.
Caster angle may be changed by sliding subframe!
-
Tighten subframe with new bolts.
Rear Axle Camber, Adjusting
Rear Axle Camber, Adjusting
Camber cannot be adjusted.
If values are outside tolerance, transverse inclination must be checked first and compensated if necessary => [ Vehicle Transverse Inclination Neutral
Position ] See: Wheel Alignment, Preparing to Measure.
If measured values are still not within specified range, check axle beam for damage and replace if necessary.
Wheel Alignment Sequence
Wheel Alignment Specifications
=> [ Front Axle ]
=> [ Rear Axle ]
=> [ Vehicle Alignment ]
Front Axle