New Beetle L5-2.5L (BPR) (2007)
Some of the functions listed above can be adapted. Refer to => [ Comfort System Central Control Module Components, Adapting ] See: Relays and
Modules - Powertrain Management/Relays and Modules - Computers and Control Systems/Body Control Module/Testing and Inspection.
DTC recognition and display
The Comfort System Central Control Module (J393 ) is equipped with OBD.
Use the "Guided Fault Finding".
The Comfort System Central Control Module (J393 ) is located behind the trim on the trim on the left side of the steering column.
CAUTION!
‹› Turn off the ignition and all electrical components.
‹› Remove the key.
Removing
-
Remove the cover on the driver side footwell and the trim on the bottom of the steering column.
-
Remove screws - 3 -.
-
Disconnect the connectors - 1 - and - 2 - and remove them from the Comfort System Central Control Module (J393) - 4 -.
‹› The number of electrical connections depends on vehicle equipment level and market version.
-
Remove the Comfort System Central Control Module (J393) - 4 -.
Installing
Install in reverse order of removal, noting the following:
-
Tighten the screws to 5 Nm.
After installing a new Comfort System Central Control Module (J393), it must be coded. Refer to=> [ Comfort System Central Control Module,
Coding ] See: Relays and Modules - Powertrain Management/Relays and Modules - Computers and Control Systems/Body Control Module/Testing
and Inspection.