New Beetle L5-2.5L (BPR) (2007)
If the specified value was obtained:
-
Replace the Oxygen Sensor (O2S) 2 in center Three Way Catalytic Converter (TWC) (G465).
If the specified value was Not obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Engine Control Module (ECM) (J220). Refer to the Repair Information.
-
Using a multimeter, check the Oxygen Sensor (O2S) 2 in Center Three Way Catalytic Converter (TWC) (G465) electrical harness connector
terminals to the Engine Control Module (ECM) (J220) electrical harness connector T121 terminals for resistance.
Specified value: 1.5 ohms Max.
If the specified value was Not obtained:
-
Check the wiring for an open, high resistance, short circuit to each other, Battery (+) or Ground.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and the voltage supply was Not OK:
-
Replace the Engine Control Module (ECM) (J220 ). Refer to the Repair Information.
-
Install the right side vehicle O2S connector cover.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Readiness Code.