New Beetle L5-2.5L (BPR) (2007)
Ignition Switch Lock Cylinder: Service and Repair
Lock Cylinder
CAUTION!
When disconnecting and connecting the Battery ( A), the procedure must be followed as described in the Repair Information. Refer to =>
[ Battery A, Disconnecting and Connecting ] See: Battery/Service and Repair/Procedures/Battery A, Disconnecting and Connecting.
Special tools, testers and auxiliary items required
‹› Steel Wire (approximately dia. 1.2 mm)
Removing
-
Remove the steering column trim.
-
Carefully remove the Anti-Theft Immobilizer Reading Coil (D2) - arrow - from the lock cylinder.
‹› The Anti-Theft Immobilizer Reading Coil (D2) is attached to the lock cylinder and cannot be replaced separately.
-
Insert ignition key into lock cylinder and turn it to "Drive ".
Key positions of lock cylinder:
1. Position "Off"
2. Position "Run"
3. Position "Start"
-
Insert a steel wire (approximately dia. 1.2 mm) into the hole - arrow - next to the key.