New Beetle L5-2.5L (BPR) (2007)
-
Put wheel bearing - 1 - , pressure piece - 2 - (put collar into bearing), and hollow piston cylinder - 3 - with tie bolt on wheel bearing housing.
-
From inside, assemble pressure piece - 4 - with wide collar to wheel bearing housing and special nut - 5 -.
-
Press in wheel bearing by actuating pump.
-
Insert securing ring with needle-nose pliers.
1. Wheel bearing
2. Thrust piece E-13-1
3. Hollow piston cylinder HKZ-15
4. Thrust piece E-10
5. Special nut E-8-214 and tie bolt
Pressing in wheel hub
-
Put wheel hub - 1 - and hollow piston cylinder - 2 - with tie bolt onto wheel bearing.
-
From inside, assemble special nut - 4 - and pressure piece - 3 - with collar to special nut.
-
Press in wheel hub by actuating pump.
1. Wheel hub
2. Hollow piston cylinder HKZ-15
3. Thrust piece E-5
4. Special nut E-8-214 and tie bolt
Installation is in reverse order of removal. Note the following:
-
Tighten bolts for control arm and ball joint on to old marks.
-
Install wheel and tighten.
Wheel Bearing Housing
Wheel Bearing Housing
Special tools, testers and auxiliary items required
‹› Thrust plate (VW 401)
‹› Punch (VW 407)
‹› Punch (VW 408 A)
‹› Thrust disc (VW 412)