New Beetle L5-2.5L (BPR) (2007)
-
Guide selector lever cable - 2 - into selector mechanism housing and press onto selector lever - 3 - using a screwdriver - 4 -.
-
Install new securing plate - 1 - for selector lever cable to shift mechanism housing.
Installation position:
Angled end of securing plate faces toward end of selector lever cable.
-
Lower vehicle
-
Pull up pull-rod and move selector lever from "P" to " S" with pull rod pulled up.
‹› Selector mechanism and selector lever cable must have freedom of movement during this, if necessary, replace selector lever cable or service shift
mechanism.
-
Pull up pull-rod and place selector lever in "P" with pull rod pulled up.
-
Install cover with seal glued on hand-tight on to selector mechanism housing.
‹› While doing this, make sure seal makes correct contact.
-
First tighten nuts - arrows A -.
-
Then tighten two bolts - arrows B -.
-
Insert protective sleeve of selector lever cable into cover.
-
Move selector lever/shift rod - 3 - at transmission in "P" position. Catch must engage in parking lock gear, both front wheels are locked (cannot be
turned together in one direction).