New Beetle L5-2.5L (BPR) (2007)
Selector Mechanism Cover and Circuit Board
Removing
-
Remove selector lever handle => [ Selector Lever Handle ] See: Selector Lever Handle.
-
Pull up pull-rod and place selector lever in "P" with pull rod pulled up.
-
Switch ignition off.
-
Remove center console.
-
Disconnect harness connector - 1 - from circuit board.
-
Pull harness connector out of hole - arrow - in bracket - 2 -.
-
Carefully pry off retaining tabs - arrows - (qty. 4).
‹› If retaining tabs - arrows - are damaged, cover must be replaced completely.
-
Remove complete shift mechanism cover upward.
-
Remove circuit board from mounts on frame - arrows -.