New Beetle L5-2.5L (BPS) (2006)
Hood Latch Release Cable: Service and Repair
Hood
Hood Release Cable
1
Hood Release Cable
‹› Removing:
-
Remove operating lever and unclip hood release cable on lock and in engine compartment.
-
Remove lower A-pillar trim.
-
Secure a welding wire or similar - approx. 1000 mm in length on cable nipple (operating lever) and pull out cable from engine compartment side.
‹› Installing:
-
Use welding wire or similar as auxiliary pulling tool.
2
Sealing Grommet
‹› Qty. 2
3
Expanding Nut
4
Operating Lever
‹› Removing and installing, refer to => [ Operating Lever ] See: Service and Repair/Hood/Operating Lever