New Beetle L5-2.5L (BPS) (2006)
Brake Caliper: Locations
Rear Brake Caliper Assembly Overview
Rear Brake Caliper Assembly Overview
‹› Install complete repair kit when servicing.
‹› New brake calipers are filled with brake fluid and are pre-bled.
‹› Apply a thin coat of assembly paste (G 052 150 A2 ) to brake cylinders, pistons and seals.
‹› In case of repair, brake calipers must always be pre-bled before being installed into vehicle (without brake pads) => [ Brake Caliper, Pre-Bleeding
] See: Service and Repair/Overhaul/Brake Caliper Piston.
1
Hex bolt, self-locking, 35 Nm
‹› Replace
‹› When loosening and tightening, counter-hold on guide pin
2
Bleeder valve
‹› Lightly grease thread with assembly paste (G 052 150 A2) before screwing in
3
Dust cap
4
Guide pins
‹› Grease before pulling on protective cap