New Beetle L5-2.5L (BPS) (2006)
-
Finally, tighten the bolts to the cylinder block and upper oil pan to 25 Nm.
-
Wipe off any sealant, which has leaked out.
-
Drive the alignment bushings in until seated, if necessary.
-
Install a new seal. Refer to => [ Crankshaft Seal, Transmission Side ] See: Seals and Gaskets/Crankshaft Main Bearing Seal/Service and
Repair/Crankshaft Seal, Transmission Side.
The rest of the installation follows the reverse of the removal procedures. When doing this note the following:
‹› Install the brake booster vacuum pump. Refer to => [ Brake Booster Vacuum Pump ] See: Brakes and Traction Control/Power Brake
Assist/Vacuum Pump/Service and Repair/Brake Booster Vacuum Pump.
‹› Install the cylinder head. Refer to => [ Cylinder Head ] See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder
Head.
‹› Install the drive plate. Refer to => [ Drive Plate ] See: Transmission and Drivetrain/Flex Plate/Service and Repair/Drive Plate.
‹› Remove the (T40069) from the cylinder block and install the locking bolt.
‹› Fill with coolant. Refer to => [ Draining and Filling ] See: Cooling System/Service and Repair/Procedures/Draining and Filling.
Tightening Specifications