New Beetle L5-2.5L (BPS) (2006)
Headlamp Alignment Actuator: Service and Repair
Halogen Headlamp Range Control Positioning Motor, From 07.2005
Halogen Headlamp
Halogen Headlamp Range Control Positioning Motor, From 07.2005
‹› Always perform a basic setting to the headlamp whenever a positioning motor is removed and installed again or replaced.
CAUTION!
‹› Turn off the ignition and all electrical components.
‹› Remove the ignition key.
Removing
-
Remove headlamp.
-
Remove the cap on the back of the headlamp.
-
Remove the reflector - 3 -=> [ (Item 3) Reflector ] See: Service and Repair/Removal and Replacement/Halogen Assembly Overview, From
07.2005.
-
Remove screws - arrows -.
-
Remove the axle - 3 - from the guide in the reflector.
-
Remove the positioning motor - 1 - with the bracket - 2 -.
-
Disconnect the connector - arrow - on the positioning motor.