New Beetle L5-2.5L (BPS) (2006)
-
For fuel tank
17
-
Lock washer
18
-
Cover for fuel tank
19
-
20 Nm plus an additional 1/4 turn (90 degrees)
-
Replace
20
-
Securing strap
-
Observe varying lengths
-
Installed location: Locating point (hole) points in driving direction
21
-
Fuel filter
-
Installed location: Arrow points in direction of flow
-
Fuel filter with attachments.
- Fuel supply system must be bled after replacing fuel filter.
22
-
Supply line
-
Black
-
Ensure seated tightly
-
To disconnect from fuel filter, press in securing ring on connecting piece.
-
To fuel rail
23
-
Vent line
-
White
-
Clipped in at top of fuel tank
-
Ensure seated tightly
-
To Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
24
-
Seal
-
Replace
-
To install, place into opening of fuel tank dry
-
Only coat inner part with fuel when installing fuel delivery unit.
25
-
Fuel delivery unit
-
Note installation position on fuel tank
-
Fuel gauge sensor, removing and installing.
-
Check fuel pump.
-
Clean strainer if soiled
26
-
Locking ring, 110 Nm
-
Ensure seated tightly
-
Use wrench T10202 for removal and installation
27
-
Supply line
-
Black
-
To fuel filter
-
Ensure seated tightly
-
To disconnect from flange and fuel filter, press in securing ring on connecting piece.
-
Clipped to side of fuel tank
28
-
Return line
-
Blue
-
To fuel filter
-
Ensure seated tightly
-
To disconnect from flange and fuel filter, press in securing ring on connecting piece.
-
Clipped to side of fuel tank
29
-
Gravity valve
-
To remove valve unclip upward out of support
-
Checking valve for throughput:
-
Valve vertical: Open
-
Valve angled at 45 degrees : Closed
30
-
Pressure retention valve
-
For fuel tank ventilation
31
-
Ground (GND) connection
-
Ensure seated tightly