New Beetle L5-2.5L (BPS) (2006)
Specified value: 1.5 ohms Max.
If the specified value was Not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground.
-
Check the wiring connection for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was OK:
-
Replace the Camshaft Position (CMP) Sensor (G40 ).
If no malfunction is found in the wiring and voltage supply was not OK:
-
Replace the Motronic Engine Control Module (ECM) (J220). Refer to the Repair Information.
-
Install the engine cover. Refer to the Repair Information.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09.
2. If necessary, erase the DTC memory => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09.
3. If the DTC memory was erased, generate readiness code => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes/Readiness Code.