New Beetle L5-2.5L (BPS) (2006)
-
Disconnect connector - 1 - and bleeder hose - 2 -.
-
Remove bolts - arrows -.
NOTE: Seal intake channel in intake manifold using a clean rag.
-
Clamp off coolant hoses using Hose Clamps Up to 25 mm dia. 3094 and disconnect them from throttle valve connection - arrows -.
NOTE: Coolant hoses only for Throttle Valve Control Module J338 heated by coolant
Installing
Installation is in reverse order of removal. When doing this note the following:
-
Replace sealing ring for throttle valve control module if damaged.
-
Make sure air hoses - 1 - and - 2 - are fitted securely.
-
During replacement, erase adaptation values and adapt Engine Control Module (ECM) to throttle valve control module Vehicle Diagnosis, Testing
and Information System VAS 5051 "Guided Functions".
Tightening torques:
Component
Nm
Throttle valve control
6.5
module to intake manifold