New Beetle L5-2.5L (BPS) (2006)
Ignition Coil: Service and Repair
Ignition Coils with Power Output Stages
Special tools, testers and auxiliary items required
‹› Ignition coil puller (T40039)
Removing
-
Remove the engine cover.
-
Disconnect the harness connector from the Secondary Air Injection (AIR) solenoid valve (N112) - arrow -.
In order to prevent damage to the wire guide, remove the ignition coils with power output stage as follows:
-
Using (T40039), pull all ignition coils only approximately 10 millimeters (mm) out of the spark plug holes, starting with ignition coil - 1 -.
-
Then, pull out all ignition coils a further 10 mm in the same sequence.
-
Disengage all connectors and pull them out only slightly.
-
After that, pull off all connectors - A -, starting at ignition coil - 1 -, and remove the ignition coils from the spark plug holes.