New Beetle L5-2.5L (BPS) (2006)
Fuel Gauge Sender: Service and Repair
Removal and Installation
Engine Code BPS (Plastic Fuel Tank)
Fuel Level Sensor
Removing
-
Remove the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Tank/Service and Repair/Removal and Replacement/Removal and Installation/Fuel Delivery Unit.
-
Disengage the connector prongs for wires - 3 and 4 - and disconnect.
-
Pry up the retaining tabs - 1 and 2 - using screwdriver and remove the sensor downward in the - direction of the arrow -.
Installing
-
Insert the sensor into the guides on the fuel delivery unit and press up until engagement.
-
Insert the connector prongs for the wires and engage.
-
Install the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service
and Repair/Removal and Replacement/Removal and Installation/Fuel Delivery Unit.