New Beetle L5-2.5L (BPS) (2006)
Specified value: Battery voltage.
If the specified value was Not obtained:
-
Check the wiring for an open, high resistance, short circuit to each other, or Ground.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
Checking Ground activation
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J220). Refer to the Repair Information.
-
Using a multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) electrical harness connector terminal
2 to the Motronic Engine Control Module (ECM) (J220) electrical harness connector T121 terminal 6 for an open circuit according to the wiring
diagram.
Specified value: 1.5 ohms max.
If the specified value was Not obtained:
-
Check the wiring for an open or high resistance.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Motronic Engine Control Module (ECM) (J220). Refer to the Repair Information.
-
Install the right side vehicle O2S connector cover.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Readiness Code.