New Beetle L5-2.5L (BPS) (2006)
Shifter A/T: Removal and Replacement
Selector Mechanism
Selector Mechanism
Removing
-
First determine whether a coded radio is installed. In this case, determine the anti-theft coding.
-
Move selector lever in position "R".
-
Switch ignition off and disconnect battery Ground (GND) cable.
-
Remove selector lever handle => [ Selector Lever Handle ] See: Selector Lever Handle.
-
Remove selector mechanism cover and circuit board => [ Selector Mechanism Cover and Circuit Board ] See: Selector Mechanism Cover and
Circuit Board.
-
Carefully pry off frame at four corners - arrows - and remove.
-
Disconnect connector - arrow - from Shift Lock Solenoid (N110).
-
Pull up pull-rod and place selector lever in "P" with pull rod pulled up.
-
Disengage locking cable - 1 - on selector mechanism from locking lever => [ Locking Cable ] See: Shift Interlock/Shift Interlock Cable/Service
and Repair.