New Beetle L5-2.5L (BPS) (2006)
‹› Thickness 22 mm
‹› Wear limit: 19 mm
‹› Pads on both sides of axle must always be replaced together
‹› Remove brake caliper housing before removing
‹› Do not separate brake discs from wheel hub with force or rust solvent, otherwise brake discs will be damaged.
3
Brake pads
‹› Vehicles up to model year 2000
‹› Thickness 14 mm
‹› Checking thickness => 14.1
‹› Pads on both sides of axle must always be replaced together
‹› Removing and installing => [ Brake Pads ] See: Brakes and Traction Control/Disc Brake System/Brake Pad/Service and Repair/Removal and
Replacement.
‹› Wear limit: 7 mm including backing plate
4
Brake caliper housing
‹› Do not remove brake hose when replacing brake pad
‹› Removing and installing => [ Brake Caliper ] See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and
Repair/Removal and Replacement/Brake Caliper.
‹› Servicing => [ Front Brake Caliper Assembly Overview ] See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and
Repair/Removal and Replacement/Front Brake Caliper Assembly Overview.
5
Guide pins, 28 Nm (18 ft lb)
6
Concealment cap
‹› Remove
7
Brake hose with ring supports and banjo fitting, 35 Nm
8
Wheel bearing housing
9
Socket-head bolt 8 Nm
10
Right front ABS wheel speed sensor (G45)/left front ABS wheel speed sensor (G47)
‹› Before inserting sensor, clean inner surface of hole and coat with securing grease (G 000 650)
11
Cover plate
12
Hex bolt, 10 Nm
13
Wheel bearing
‹› Always replace after removal
14
Circlip
15
Wheel hub with rotor
16
Brake pads