New Beetle L5-2.5L (BPS) (2006)
No shim will be installed on side of clutch housing.
Pulling off inner races/tapered roller bearing
-
Before installing puller, set thrust piece ( 40 - 105) onto differential housing.
‹› Both tapered roller bearing inner races are pulled off from the differential housing in the same way.
Pressing on inner races/tapered roller bearing
‹› Tapered roller bearing inner race for transmission housing and clutch housing are pressed on using the same special tools.
Pulling outer race/tapered roller bearing out of transmission housing
A Support, e.g. ( Kukko 22/2)
B Internal puller 46 to 58 mm, e.g. (Kukko 21/7)
Pressing outer race/tapered roller bearing into transmission housing