New Beetle L5-2.5L (BPS) (2006)
Installing
-
Drive in new sealing ring to stop. Do not distort oil seal.
-
Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128 A1).
-
Install flange shaft, secure with countersunk bolt and tighten to 25 Nm.
-
Install drive axle.
-
Bolt on wheel
-
Checking and filling up gear oil => [ Gear Oil, Checking and Filling ] See: Fluid - M/T/Service and Repair.
-
Install center and left sections of sound insulation below engine/transmission.
Tightening Specifications