New Beetle L5-2.5L (BPS) (2006)
Windshield Wiper Motor, Removing from Wiper Frame
-
Pry the linkage rods - 1 - off the crank using a screwdriver.
-
Remove the screws - 2 - on the Windshield Wiper Motor (V).
-
Remove Windshield Wiper Motor (V) from wiper frame.
-
Remove nut - 3 -.
-
Remove crank.
Windshield Wiper Motor in Wiper Frame, Installing
-
Connect the connector to the Windshield Wiper Motor (V) and then let the Windshield Wiper Motor ( V) run all the way to its end position. Then
quickly operate the windshield wiper switch.
-
Disconnect the connector once again and tighten the screws on the Windshield Wiper Motor (V).
Tightening specifications, refer to => [ Windshield Washer System Assembly Overview ] See: Description and Operation/Windshield Wiper System
-
Install the crank and adjust the rods to that they form a single line - as shown in the illustration -.
-
Tighten nut.
Tightening specifications, refer to => [ Windshield Washer System Assembly Overview ] See: Description and Operation/Windshield Wiper System
-
Press the rods onto the crank.