volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Procedures|Page 15071 > < Procedures|Page 15069
Page 2
background image

4

Rear Spoiler Motor (V52)

‹› Removing and installing, refer to => [ Rear Spoiler Motor ] See: Rear Spoiler, rear spoiler drive, removing and installing

5

Rear Spoiler Switch (E127)

‹› Below instrument panel near steering column

‹› For raising and lowering rear spoiler "manually", refer to => [ Manual Rear Spoiler, Raising and Lowering ] See: Rear Spoiler

(Overview)/Manual Rear Spoiler, Raising and Lowering

6

Rear spoiler adjustment warning lamp

7

Rubber buffer

Rear Spoiler Function

Rear Spoiler

Rear Spoiler Function

Rear spoiler raises automatically when vehicle speed reaches approx. 150 km/h. If sunroof is tilted or open at this speed, it will close automatically. 

If speed drops below 130 km/h, rear spoiler will lower automatically. Sunroof will not open again.

Rear Spoiler Control Module (J223) detects malfunctions in rear spoiler system and stores them in permanent memory.

Using self-diagnosis, these malfunctions can be read out and appropriate repair measures can be taken.

Malfunction in rear spoiler system will be indicated via warning lamp for rear spoiler - arrow - when operated automatically. Additionally, warning
lamp lights up when rear spoiler is raised "manually", refer to => [ Manual Rear Spoiler, Raising and Lowering ]. See: Rear Spoiler
(Overview)/Manual Rear Spoiler, Raising and Lowering

CAUTION!
Vehicle behavior may change when rear spoiler does not raise!

Manual Rear Spoiler, Raising and Lowering

Rear Spoiler

Manual Rear Spoiler, Raising and Lowering

Rear Spoiler Switch (E127) is located below instrument panel (near steering column) for raising and lowering rear spoiler "manually". "Manual"
raising and lowering of rear spoiler is only possible when vehicle is stationary and at speeds below 100 mph (150 km/h).

Rear spoiler will raise completely in one movement when ignition is on and switch is operated in position - 1 -. Lowering is executed in several steps
until limit stop when switch is in position - 2 -. 

Procedures|Page 15071 > < Procedures|Page 15069