New Beetle Convertible L5-2.5L (BPR) (2007)
/Page-1158002.png)
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J220). Refer to the Repair Information.
-
Using a multimeter, check the Manifold Absolute Pressure (MAP) Sensor (G71) electrical harness connector terminal to the Motronic Engine
Control Module (ECM) (J220) electrical harness connector T121 for resistance.
Specified Value: 1.5 ohm max.
If the specified value was Not obtained:
-
Check the wiring for an open circuit, high resistance, short circuit to each other, Battery (+) or Ground.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace Manifold Absolute Pressure (MAP) Sensor ( G71).
If the specified voltage supply was Not obtained:
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to the Repair Information.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J220). Refer to the Repair Information.
-
Using a multimeter, check the Manifold Absolute Pressure (MAP) Sensor (G71) electrical harness connector terminals to the Motronic Engine
Control Module (ECM) (J220) electrical harness connector T121 terminals for resistance.
Specified value: 1.5 ohms max.
If the specified value was Not obtained:
-
Check the wiring for an open circuit, high resistance, short circuit to each other, Battery (+) or Ground.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and if the voltage supply was Not OK:
-
Replace the Motronic Engine Control Module (ECM) (J220). Refer to the Repair Information.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
