New Beetle Convertible L5-2.5L (BPR) (2007)
-
Remove the Motronic Engine Control Module (ECM) ( J220). Refer to the Repair Information.
-
Using a multimeter, check the Secondary Air Injection Sensor 1 (G609) electrical harness connector terminals to the Motronic Engine Control
Module (ECM) (J220) electrical harness connector T121 terminals for an open circuit according to the wiring diagram.
Specified value: 1.5 ohms Max.
If the specified value was Not obtained:
-
Check the wiring for an open, high resistance or short to ground.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring:
-
Replace the Motronic Engine Control Module (ECM) (J220). Refer to the Repair Information.
-
Install the engine cover with air filter. Refer to the Repair Information.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Readiness Code.