New Beetle Convertible L5-2.5L (BPR) (2007)
Control Module: Service and Repair
09G Transmission
Transmission Control Module
Removing
-
Switch ignition off.
-
Remove defroster duct.
‹› Harness connector of control module may only be disconnected or connected 30 seconds after ignition is switched off.
-
Release harness connector - arrow 1 - and remove it from Transmission Control Module (TCM) - arrow 2 -.
‹› Separating the connector automatically resets the adaptation values of the transmission. The control module must relearn the values once the
transmission is operational again. The quality of the gear changes may deteriorate during the "learning" process.
-
Remove nuts - arrow 3 -.
-
Remove control module.
Installing
Installation is in reverse order of removal.
-
When installing, insert multi-pin harness connector on to pins of Transmission Control Module (TCM) (J217) - arrow 1 - and then engage
multi-pin harness connector - arrow 2 -.