New Beetle Convertible L5-2.5L (BPR) (2007)
-
Pull bolt - 2 - out of mounting bracket and screw mounting bracket to chassis again.
With Automatic Headlight Range Control
-
Remove coupling rod of left rear level control system sensor (G76) from rear axle => [ Left Rear Level Control System Sensor Overview ] See:
Sensors and Switches - Suspension/Ride Height Sensor/Service and Repair/Left Rear Level Control System Sensor Overview.
Continuation for All
-
Place engine/transmission jack (V.A.G 1383 A ) under left spring mount of rear axle.
-
Press left spring mount using engine/transmission jack (V.A.G 1383 A) upward far enough so that bonded rubber bushing can be pulled out.
-
Insert bolt - 1 - for mounting bracket at rear axle again and clamp a piece of wood with a height of a = approximately 80 mm between bolt and rear
axle.
-
Pull bonded rubber bushing out of rear axle using slide hammer-complete set (VW 771) - 2 - and thrust piece (3416/2) - 3 -.
Installing
Bonded rubber bushing is marked - 1 - on front side.
These marks must align with edge - arrow - of trailing link - 2 -.
-
Insert bonded rubber bushing - 1 - into rear axle using thrust piece (3416/2) - 2 -.