volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Transmission Control Module (TCM) J217, Replacing|Page 6947 > < Transmission Control Module (TCM) J217 CAN-Bus Terminal Resistance, Checking|Page 6944
Page 1
background image

Control Module: Service and Repair
Transmission Control Module (TCM) J217, Replacing

Transmission Control Module (TCM) J217, Replacing

NOTE:

-

To achieve optimal anti-theft protection for the vehicle, an anti-theft immobilizer was installed. The anti-theft immobilizer is a system for
enabling/locking the Transmission Control Module (TCM) J217.

-

To perform adaptation of the anti-theft immobilizer.

Procedure

Check the identification of the previous Transmission Control Module (TCM) J217 as follows:

-

Connect the scan tool.

-

Switch the ignition on.

-

Select "Diagnostic mode 9: Vehicle information."

-

Select the "Test-ID 04: Calibration identification".

-

The Transmission Control Module (TCM) J217 identification will be displayed, e.g.: 09G27750 L 0301

-

End diagnosis and switch the ignition off.

Removal

-

Remove the left wheelhousing liner.

-

Disconnect the Transmission Control Module (TCM) J217 electrical harness connector - A -.

-

If equipped, disconnect the right side - 2 - and the left side - 5 - turn signal electrical harness from the Transmission Control Module (TCM) J217.

-

Remove the Transmission Control Module (TCM) J217 bracket screws - 3 -.

-

Remove the Transmission Control Module (TCM) J217 with the bracket attached.

-

Remove the bracket screws - 4 - and the bracket from the Transmission Control Module (TCM) J217.

Installation

Transmission Control Module (TCM) J217, Replacing|Page 6947 > < Transmission Control Module (TCM) J217 CAN-Bus Terminal Resistance, Checking|Page 6944