New Beetle GL L4-2.0L (AZG) (2002)
/Page-929002.png)
7
Self-locking nut
^
Tighten to 20 Nm (15 ft. lbs.)
^
Always replace
8
Bolt
^
Tighten to 9 Nm (80 inch lbs.)
9
Cap nut
^
Tighten to 9 Nm (80 inch lbs.)
10
ABS/EDL hydraulic unit
11
ABS control module
12
Brake line connection
^
Hydraulic unit to left front brake caliper
13
Brake line connection
^
Hydraulic unit to right rear wheel cylinder/caliper
14
Brake line connection
^
Hydraulic unit to left rear wheel cylinder/caliper
15
Brake line connection
^
Hydraulic unit to right front brake caliper
16
Brake line
^
Brake master cylinder/primary piston circuit to hydraulic unit
17
Brake line
^
Master brake cylinder/secondary piston circuit to hydraulic unit
18
Self-locking nut
^
Tighten to 20 Nm (15 ft. lbs.)
^
Always replace
19
Heat shield Only for vehicles with 110 kW engine
20
Self-locking nut
^
Tighten to 20 Nm(15 ft. lbs.)
^
Always replace
21
Seal
^
Always replace
22
Seal
23
Vacuum hose
^
Insert into brake booster
24
Gasket
^
For brake booster
25
Self-locking nut
^
Tighten to 20 Nm (15 ft. lbs.)
^
Always replace
26
Boot
^
Be sure boot is properly seated.
27
Bracket
Brake lines from brake master cylinder to hydraulic unit, connecting
Fig. 1 Vehicles with ABS
A Secondary piston circuit
B Primary piston circuit
1
Hydraulic unit to right front brake caliper
2
Hydraulic unit to left rear wheel cylinder/brake caliper
3
Hydraulic unit to right rear wheel cylinder/brake caliper
4
Hydraulic unit to left front brake caliper