New Beetle GL L4-2.0L (AZG) (2002)
/Page-936003.png)
1
- Screw
^
Tighten to 4 Nm (35 inch lbs.)
2
- Brake disc
^
Thickness 25 mm (0.984 inch)
^
Wear limit: 22 mm (0.866 inch)
^
When worn always replace brake disc pairs on both sides
3
- Exterior brake pads
^
Thickness: 14 mm (0.551 inch)
^
Always replace brake pads on same axle on both sides of vehicle at same time
4
- Interior brake pad
^
Thickness: 14 mm (0.551 inch)
^
Always replace brake pad on front left axle
^
From 2000 > left wheel brake pad with pad wear indicator
5
- Retaining spring
^
Insert in both brake caliper housing drillings
6
- Brake carrier
^
Supplied as replacement part assembled with sufficient grease on guide pins
^
if protective caps are damaged, use repair kit
^
Use grease packet supplied to lubricate guide pins
7
- Brake caliper housing
^
Do not disconnect brake hose when changing brake pads
8 - Guide pins
^
Tighten to 28 Nm (21 ft. lbs.)
9
- Protective cap
