New Beetle GL L4-2.0L (AZG) (2002)
-
End output (function 06).
-
Switch off ignition and disconnect Data Link Connector (DLC).
Without Manufacturer Scan Tool
The manufacturer does not provide a procedure for reading diagnostic trouble codes without a scan tool.
With Manufacturer Scan Tool
Diagnostic Trouble Code (DTC) Memory, Erasing (Function 05)
NOTE: Erasing DTC memory (function 05) is only possible after checking DTC memory (function 02). If DTC memory cannot be erased, check DTC
memory again and rectify indicated malfunctions
Prerequisites
-
Check DTC memory. See: Reading and Clearing Diagnostic Trouble Codes/Diagnostic Trouble Code (DTC) Memory, Checking (Function 02)
-
All malfunctions repaired.
After checking DTC memory:
Indicated on display (select function):
Rapid data transfer
HELP.
Select function XX
-
Press buttons -0- and -5- to select function 05," Erase DTC memory."
Indicated on display:
Rapid data transfer
Q
05 Erase DTC memory
-
Press -Q- button to confirm input.
Indicated on display (DTC memory is now erased).
Rapid data transfer
->
DTC memory is erased!
-
Press -> button.
Indicated on display (select function):
Rapid data transfer
HELP
Select function XX
-
End output (function 06). See: Scan Tool Testing and Procedures/End Output (Function 06)
NOTE:
-
If this appears in the display, test sequence is faulty.
WARNING!
DTC memory was not checked
-
If this appears in the display, test sequence is faulty.
Rapid data transfer
->
DTC memory was not checked
Adhere exactly to test sequence: First check DTC memory, repair malfunctions if necessary, then erase.
Without Manufacturer Scan Tool
The manufacturer does not provide a procedure for clearing diagnostic trouble codes without a scan tool.
Diagnostic Trouble Code Tests and Associated Procedures
For information regarding diagnosis of all B, C, P, U and Manufacturer Codes - See: Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures