New Beetle GL L4-2.0L (AZG) (2002)
Read Measuring Value Block (function 08)
The measuring value block is divided into 4 display group numbers. Each display group contains individual display fields. See: Scan Tool Testing and
Procedures/Measuring Value Blocks (Function 08)/Evaluating Measured Value Blocks
Use this function to observe various instrument cluster inputs.
-
Connect VAG 1551 Scan Tool (ST), input address word 19 " "Gateway" and then press -> button until "Select function XX" is shown in display
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -8- to select function "Read measuring value block".
Indicated on display:
Rapid data transfer
Q
08 - Read Measuring Value Block
-
Press -Q- button to confirm input.
Indicated on display:
Read Measuring Value Block Help
Enter display group number XXX
-
Using the Scan Tool (ST) button pad, enter the required display group number (following example shows display group 001).
-
Press -Q- button to confirm input.
Indicated on display: (1.. .4 = Display fields)
Read Measuring Value Block 1
->
1
2
3
4
NOTE: Interpreting display groups and evaluating measured values in individual display fields. See: Scan Tool Testing and Procedures/Measuring
Value Blocks (Function 08)/Evaluating Measured Value Blocks
With the printer switched on, the information on the display is printed out.
To easily change between display groups, proceed as follows:
-
Displayed after pressing -C- button.